NABAKEM Resin Stripper SS#1
● Packaging Unit
▶ Aerosol 420㎖/can, 20cans/Box
● Features
▶ NABAKEM Resin Stripper SS#1 is a resin stripper containing strong exfoliation solvent penetrating into the resins fixated on metal mold and softening them.
▶ It is manufactured for GRP industry. Also, the product can remove zinc stearate and vinyl resin fixed on mold surface and strips plastic dye spot.
▶ No influence to metal surface. No residues.
▶ Using the solvents lie aceton and MC have created many side effects.
▶ NABAKEM Resin Stripper SS#1 has same dissolubility and cleanability without these side effects.
▶ As pretreatment in heating process requred by other resin strippers containing water is not necessary, using finished product creates better effects.
▶ Unlike existing solvents including aceton and MC, its vaporization speed is much slower.
▶ It does not do any harm to human body even when inhaled.
▶ Much lower amount is required for the same effects as existing solvents.
▶ Therefore it is more cost-effective. With high igneous point and lower danger of fire, it reduces the costs for facilities preventing harmful materials.
(Onsite test showed that one drum of Resin Stripper SS#1 substituted from 17 drums of aceton and MC.)
● Uses
▶ Following resins fixed on metal mold surface
- polyacetal resins(Delrin)
- polyamides (Nylon-Zytel)
- polyvinylchloride resins
- other resinous materials
- polyvinyl formal resins
- polyester (Mylar)
- certain elastomers
- urethanes
▶ Manual tools
▶ Injection system
▶ Mixing tank
▶ Feeder lines
▶ Compressor
▶ Injection mold
▶ Automated production system
● How to use
▶ Apply it sufficiently to make it penetrate into whole fixated contaminants, and leave it for about five minutes.
▶ When it fully penetrates into contaminants , rub with cloth or tool to remove.
▶ In case of mold for injection molding, apply with mold mounted on injection molder and tap applied surface lightly 30 minutes later.
▶ Repetition over two or three times can remove contaminants
1. SPRAY method : Short-time spray during machinery operation removes polyacetal residues in mold, enabling you to proceed with the next work.
Recommended mold temperature is 82℃∼93℃. As residues melt away down through eject part, apply the product three or four times for finish even after residues are removed.
2. Dipping method
3. BRUSHING method
● Cautions
▶ Keep away from fire.
▶ Do not spray it toward flame.
▶ Do not throw empty can into fire.
▶ Keep it in a place below 40℃.
▶ Frequent use requires good ventilation.
▶ Do not use it to human body.
▶ Flush contaminated eye(s) or skin with water immediately.
▶ This product does not belong to harmful materials subject to Toxic Chemicals Regulation Act.
▶ Application at mold surface temperature below 100℃ does not cause fire.
▶ Do not use it in the room using fire.